Bind a DSM2 receiver to a Walkera DEVO transmitter

Bind a DSM2 receiver to a Walkera DEVO transmitter

I’ve created a new video in which I show you the steps needed to bind a DSM2 or DSMX receiver to a Walkera DEVO transmitter. See more below…

The video walks you step by step through the process of setting of a model in the transmitter to use the DMS2 protocol. Then I use a HobbyKing OrangeRX R615 DMS2 receiver to show you the detailed bind process.

This video assumes that you already installed the deviation software to your DEVO transmitter. If you have not installed deviation yet, you might want to watch this video in which I show the installation processed step by step:
Install DEVIATION on a Walkera Devo transmitter

8 Comments on “Bind a DSM2 receiver to a Walkera DEVO transmitter

    • Yes of course. In this mode it will bind with any models that have a DSM2 (or DSM2 compatible) receiver in them.

    • Please go to http://www.deviationtx.com/ for further info on which transmitters are supported.
      At the moment it lists: DEVO 6/6S/7E/8/8S/10/12/12S/F7*/F12E*
      So your’ F12E should be good to go (as long as you use the latest version)

    • No hardware mod is needed, if that’s what you mean. You need to update the firmware of the transmitter nothing more. With the new firmware you can set the DEVO transmitter to use DSMX as transmitter protocol.

Leave a Reply

Your email address will not be published. Required fields are marked *

Please type the characters of this captcha image in the input box

Please type the characters of this captcha image in the input box

*